Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
ing accessories, switch off the power
source and disconnect the machine
from the mains and make sure that
all moving parts have stopped mov-
ing. Allow the machine to cool down
before inspections, adjustments,
etc. Maintain the machine with care
and keep it clean.
• Always allow the machine to cool
down before putting into storage.
• When performing maintenance on
the shredder, keep in mind that al-
though the power source is switched
off by the safety device's locking
function, the shredder can still be
moved.
• For safety reasons, replace parts
that are worn out or damaged. Only
use original spare parts and acces-
sories.
• Never try to bypass the safety de-
vice's locking function.
• Switch off the machine before you
attach or remove the collection bag.
Pull the plug out of the socket and
make sure that all moving parts
have come to a complete standstill:
• Before leaving the Vac-Blower unat-
tended for period;
• Before clearing any blockage;
• Before checking, cleaning or carry-
ing out any work.
• After contact with a foreign object.
Take the following steps before you
restart and operate the machine:
- Inspect the machine for damage;
- Replace or repair damaged parts;
- Check for loose parts and tighten
them.
• If a foreign body, or other debris,
is accidentally feed into the Vac-
Blower, stop it immediately and do
not use the Vac-Blower until it has
been checked and you are sure that
the entire Vac-Blower is in a safe
operating condition.
• If the leaf blower/vacuum makes
unusual noises or starts to vibrate,
STOP the device immediately and
pull the plug out of the socket. Make
sure that all moving parts have come
to a complete standstill and find the
cause. Replace or repair the dam-
aged parts. Check the device for
loose parts and tighten them before
you restart and operate the machine.
Excessive vibration can damage the
leaf blower/vacuum and injure the
operator.
Unpacking
Due to modern mass production techniques, it is unlikely
that your power tool is faulty or that a part is missing. If
you find anything wrong, do not operate the tool until the
parts have been replaced or the fault has been rectified.
Failure to do so could result in serious personal injury.
Preparing of the blower vac prior to use
Warning!
The Vac-Blower must not be used or switched on
until it has been fully assembled.
Assembly
Intake/ Air outlet tube (Pic.2 and 3)
Press the button (2.1) and slide the air duct (2.2), the air
duct can be adjusted based on user height, adjust the
height up to 300 mm maximum, 30 mm is a height.
Fitting the debris collection bag (Pic.4 and 5)
Before fitting the debris collection bag ensure that the
Vacuum/Blow selector lever operates smoothly and that it
is not obstructed by debris from the previous use.
When users install the collection bag: turn the support
(4.1) frame into the correct position of housing and make
sure the support (4.2) lock in holding fixture (4.3).
26
Advertenties
Hoofdstukken
Inhoudsopgave
