Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
REPLACING THE LAMP
Note:
This appliance is equipped with LED light strips. They can be used for a long time. In case a LED light
strip is blown, it must be replaced by a qualified person to avoid any hazard. Contact the Inventum
service department.
RESETTING A SATURATION INDICATOR
The control of the appliance occasionally shows an indicator on the display for certain cleaning and replacing
intervals.
1. Make sure that the appliance is switched off.
2. Touch the timer button for a few seconds to reset a saturation indicator.
7
Troubleshooting
GENERAL TROUBLESHOOTING PROCEDURE
1. Try to find a solution for the problem with the help of the troubleshooting table.
2. If you cannot find a solution for the problem, contact the Inventum-servicedienst.
TROUBLESHOOTING TABLE
Problem
The motor does not operate.
The appliance does not operate
correctly or makes an unusual
sound.
8
General terms and conditions of service and warranty
5-year Inventum warranty!
1. Customers enjoy a 5-year full manufacturer's warranty on all Inventum products.
2. Within this period, a defective product or part, which makes normal functioning of the product or part impossible,
will always be repaired free of charge or, if repair is not possible and/or does not provide a solution, replaced (by
the same or equivalent products). The assessment of this lies with Inventum.
3. In order to make a claim under the 5-year Inventum warranty, you must, within two months after discovering
the fault or defect, either return the product to the shop where you bought it, or contact the Inventum customer
service department by using the form at
4. The warranty period starts from the date stated on the product's original sales receipt.
Possible cause
The mains plug is not connected.
There is no mains supply.
There is a problem with the fuse.
The dimension of the outlet is not
correct.
The outlet has a blockage.
The grease filter is dirty.
The carbon filter is worn.
'https://www.inventum.eu/service'
Possible solution
Connect the mains plug.
•
Do a check if the mains plug is
correctly connected to the mains
socket.
•
Make sure that the mains supply
is on.
Do a check on the fuse box.
Make sure that you use the correct
dimension during installation. Refer
Installation
to chapter
.
Remove the blockage.
Clean the grease filter. Refer to
Cleaning the grease filter
section
Replace the carbon filter. Refer to
Replacing the carbon filter
section
(optional)
.
.
English
.
•
33
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
