Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Problem
Water flows on the
ground.
The temperature in the
appliance is too low.
The temperature in the
appliance is too high.
The temperature in the
refrigerator is too high.
Replacing the lamp
1. Disconnect the mains plug from the mains socket.
2. Remove the screw from the lamp cover.
3. Remove the lamp cover (refer to the il-
lustration).
4. Replace the used lamp with a new lamp
of the same power and specifically de-
signed for household appliances. (the
maximum power is shown on the lamp
cover).
5. Install the lamp cover.
6. Tighten the screw to the lamp cover.
7. Connect the mains plug to the mains socket.
8. Open the door. Make sure that the lamp comes on.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Contact the Service Center.
Possible cause
The melting water outlet does
not flow in the evaporative tray
above the compressor.
The temperature regulator is
not set correctly.
The temperature regulator is
not set correctly.
The door is not closed correctly. Refer to "Closing the door".
The product temperature is too
high.
Many products are stored at
the same time.
There is no cold air circulation
in the appliance.
What to do if...
Solution
Attach the melting water outlet
to the evaporative tray.
Set a higher temperature.
Set a lower temperature.
Let the product temperature de-
crease to room temperature be-
fore storage.
Store less products at the same
time.
Make sure that there is cold air
circulation in the appliance.
29
Advertenties
Hoofdstukken
Inhoudsopgave
