Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Maximum diameter and height of the gas
bottle: 300 mm × 580 mm (Ø × H).
max. Ø 300 mm
A gas bottle is not supplied with this product.
Do not drop the gas bottle or handle it roughly
or improperly.
When the product is not in use, the gas bottle
must be disconnected from the product. Put the
protective cap on the gas bottle after the gas
bottle has been disconnected from the product.
The gas bottle must be stored outside of the
product.
Gas bottles may not be stored in rooms below
ground level, in the stairwells, passages and
passageways of buildings, or in the immediate
vicinity of the same.
The valves must be fitted with valve protective
caps and lock nuts. Gas bottles – even empty
ones – must be stored upright.
Gas bottles must be stored outside in an
upright position and out of the reach of
children.
Connecting the gas bottle
DANGER! Risk of fire and explosion!
m
Place the gas bottle in the gas bottle holder
(Fig. I). Never place the gas bottle on the other
side of the base plate
Do not keep a second gas bottle in the cabinet.
[
.
[
]
Before connecting the gas bottle to the
product, remove any dirt from the heads of the
gas bottle, the regulator or the burner. Dirt,
spiders and insects could be inside and block
the burner or Venturi tube at the opening. A
blocked burner can cause a fire under the
product.
Clean blocked burner openings with a pipe
cleaner.
Do not use an additional seal.
Do not block the ventilation openings when
using the gas bottle. The ventilation openings
of the gas bottle must stay open at all times.
Before each use, check all connections for gas
leaks. Perform the test with soapy water.
Never use a naked flame to find leaks.
Replace the gas bottle away from any source
of ignition.
1. Place the gas bottle in the gas bottle holder
in the base plate
2. Connect the low pressure regulator
gas bottle by tightening it on with your hands.
3. Follow the instructions enclosed with the
regulator.
Checking for gas leaks
1. Mix 1 part of washing-up liquid to 3 parts of
water (approx. 50 ml).
2. Rotate all knobs to the OFF position.
3. Connect the low pressure regulator
gas bottle (see "Connecting the gas bottle").
4. Switch on the burner with the knob.
5. Switch on the gas supply by opening the gas
bottle's fitting.
6. Apply the soapy water to the gas hose
and all connections. If bubbles appear, this
indicates a leak. Replace the defective part
immediately.
]
.
[
]
to the
[
]
to the
[
]
[
GB/IE/NI
[
]
]
9
Advertenties
Hoofdstukken
Inhoudsopgave
