Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Filling the Water Tank
PLEASE NOTE!
■
When the water tank is fi lled, the main unit must not be tilted, turned upside down or
laid or placed on its side. Water could leak out!
1. Flip up the stem mount (6) on the main unit (13). It must be upright so that the device
is deactivated and cannot be switched on accidentally.
Use
Switch the device off after each surface has been cleaned as this will considerably
increase the operating time on each battery charge.
1. Tilt the stem mount (6) on the main unit (13) back a little using the handle (2) in
order to trigger the release mechanism and activate the device. The battery status
display (9) lights up.
2. Press the On / Off switch (1) on the handle to switch on the device. The two cleaning
feet (8) start to vibrate and the LEDs (12) switch on.
PLEASE NOTE: If the device cannot be switched on, the handle may need to be
resynchronised with the main unit (see the "Synchronising the Handle with the Main
Unit" chapter).
3. Guide the device over the surface which is to be cleaned or polished.
4. If necessary, press the spray trigger (1) on the handle to make the fl oor damp with the
aid of the spray nozzle (11).
5. To switch off the device, press the On / Off switch on the handle again. The LEDs
switch off and the cleaning feet stop vibrating.
6. Tilt the stem mount on the main unit up a little using the handle in order to trigger
the release mechanism and activate the device. You must feel the stem engage.
The battery status display goes out.
07476_07656_DE-EN-FR-NL_A5_V3.indb 19
07476_07656_DE-EN-FR-NL_A5_V3.indb 19
19
2. Open the water tank cap (7) on the main unit.
3. Fill the water tank with water using the measuring cup
(max. 250 ml).
4. Close the water tank cap.
EN
04.11.2020 13:51:58
04.11.2020 13:51:58
Advertenties
Hoofdstukken
Inhoudsopgave
