Advertenties
Beschikbare talen
Beschikbare talen
C
Useful information
Fault
Too much foam has formed
in the dispenser drawer.
The result of the washing
cycle is not satisfactory.
The result
of the washing cycle is not
satisfactory.
As soon as the machine is
supplied with water, leaks
can be observed.
There is no visible water in
the drum during washing.
There is some washing
product residue on the
laundry.
All manuals and user guides at all-guidesbox.com
Possible cause
Too much washing
product has been used.
The wrong washing
product was used.
The laundry is too dirty
for the selected program.
There isn't enough
washing product.
The drum is overloaded.
Hard water.
The laundry is too tightly
packed in the drum.
The end of the drain hose
is too low in relation to
the machine.
No fault. The water is
located in a part of the
drum that is not visible.
Some undissolved
particles of washing
product may occur in the
form of white spots on
the laundry.
33
EN
Troubleshooting
Press the Start/Pause button.
To stop foam from forming,
dilute a tablespoon of fabric
softener in ½ L of water. Then
pour it into the dispenser
drawer. Wait 5 to 10 minutes.
Then press the Start/Pause
button.
Only use washing products
made for washing machines.
Use the program table to
choose the most suitable
program.
Use the amount of washing
product recommended on the
packaging.
Check that the maximum
capacity for the selected
program has not been
exceeded.
Increase the amount
of washing product by
following the manufacturer's
instructions.
Make sure that the laundry is
evenly distributed.
Make sure that the drain hose
is fitted at a suitable height
(**) .
.....................
Perform an additional rinse or
clean the laundry with a brush
after drying.
Advertenties
