Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
MAINTENANCE
Replacing the oven lamp
EN 20
1. Open the oven door fully and turn the pawls back as far
as they will go.
2. Close the door slowly so that the clips are in the flanges (in which
the pawls fit).
3. At approximately 15° (relative to the closed door position) lift the
door slightly upwards and lift it out of both hinge holders.
Use the reverse order to assemble the door.
1. Insert the door at an angle of 15° in the hinges on the front of the
appliance and push the door forwards and downwards so that the
hinges slide into their notches.
Check to be sure the hinge notches are properly in place.
2. Then open the door fully and turn the pawls back to their initial
position.
3. Close the door slowly and check that it closes properly.
If the door does not open or close properly, make sure the hinge
notches are positioned correctly in the hinge holders.
Before replacing the oven lamp, switch off the appliance by
removing the plug from the socket or switching off the fuse in the
fuse box. Allow the appliance to cool down. Wear hand protection
when removing the lamp.
The appliance contains a light source of energy efficiency class G.
1. Unscrew the glass cover (anticlockwise) and replace the oven lamp.
2. Fit a new lamp with the same specifications (230 V, 40 Watt, type
G9, resistant to 250 °C).
3. Screw the glass cover back on tightly.
The lamp in this household appliance is only suitable for illumination of
this appliance. The lamp is not suitable for household room illumination.
The lamp is consumable material and is not covered by the guarantee..
Advertenties
Hoofdstukken
Inhoudsopgave
