EN
EN
Manual
Manual
- Do not stand, sit on, jump or throw with the lamp at all times.
- Do not throw this product in the air to avoid damage caused by falling.
- Only use the lamp for its intended designed use as a light.
- Under extreme conditions the battery cells can cause leaking. If that
fluid touches the skin then please clean directly with water and soap. If
within the eyes then clean with water for at least 10 minutes and consult
a doctor.
- Never touch the plug contacts with sharp or metal objects.
- Use only the original power supply and original accessories.
- Protect the device from special liquids and vapors
Read and follow all safety instructions
- This IPx5 product is suitable for outdoor use.
- Do not install near a gas or other sources with a similar heating process.
- Do not use the product outside its intended use.
- Read and follow all instructions that are indicated on the product or
supplied with it.
- Keep this manual for future reference or for third parties.
Instructions for use and maintenance
When disassembling, carefully remove the product from its location
(ground, trees, bushes, table etc.) to avoid any pressure on the Solar Light
that could damage the component elements.
In case of non-use, store the product in a cool and dry place away from
direct sunlight and switch to the OFF position.
Caution: NON-Replaceable LED lights! If the light has reached the end of
its life, the lamp must be disposed of in accordance with local disposal
regulations.
Note:
A) Use with caution at all times.
B) Product specifications are subject to change without notice.
C) If disassemble the device without authorization, we cannot guarantee
the quality.
Security and important safety instructions
Class III equipment: Class III equipment: This is a class III device
and can only be used with low voltage power, connection only to SELV
power-circuits.
Troubleshooting
Light does not turn on?
- The solar panel is clean (if not, please clean it).
- The solar cell was mounted so that it is able to receive as much as possible
direct sunlight during the day.
- The battery is sufficiently charged (if not, leave for 1~2 sunny days
charging in the OFF position or charge it by Type-C USB cable way).
Light flashes or low light?
- Weak battery: Let the lamp charge again for 1~2 sunny days (or 3~4
"Ordinary" days) in the OFF position.
For best results, you need to replace the battery every 24-36 months. When
replacing the batteries, use only the type: 18650 3.7V 2200 mAh Li-Ion
batteries. Use only the same type and same specification of batteries in
the light. Never mix the batteries. lt is time to replace the batteries when
a shorter operating time than normal is detected, even though the solar
light receives a full charge of 8 hours in direct sunlight. Remove the battery
compartment cover on bottom of the main housing using a screw driver to
remove the screws, remove the cover and rubber seal (if applicable) to gain
access to the battery compartment. Delete the old battery, and dispose it
correctly according local law (see below). When refitting the cover, make
sure that the gasket and rubber sealing is properly positioned to prevent
the ingress of water. Make sure the new battery is rechargeable and is an
1x 3.7V Li-Ion 2200 mAh rechargeable 18650 battery also available at www.
flinqproducts.nl.
Note: Non-professionals please do not disassemble the lamp yourself!
Install the new battery and take care of the proper connection. Close the
battery compartment with the screws and make sure the sealing is done
properly.
Factory reset
Press the mode button for 3 seconds to go back to factorty settings.
FlinQ Smart Outdoor Orion