Advertenties
Beschikbare talen
Beschikbare talen
EN
Manual
Note
During winter time or when the sunshine duration is short, it is suggested
to switch to power OFF and charge when sunlight is available before
power ON again
Note
If there's sunlight or other lights on the solar panel, the lamp will not be
ON even if the ON/OFF switch has been turned ON. During testing, other
object (paper board, hand or arm) should be used to cover the complete
solar panel, then the lamp will be ON after turning on the ON/OFF switch
(and/or switched ON by APP). Select a location that is not located close
to other light sources, such as for example street lighting, because this
enables the lamp to be switched off automatically when set in AUTO ON
setting (by APP).
Battery warning note
New batteries must be recharged and discharged 3 ~ 5 times before
their full function use time is released. Charge indoors only at room
temperature and only under supervision during daytime. Disconnect
from the charger when the battery is fully charged, as overcharging
can shorten battery life. Lithium batteries should only be charged with
constant current/constant voltage (CC/CV). When not in usage, the charge
in a fully charged battery slowly disappears. Do not place the product
near a heat source or expose it to direct sunlight, dust, moisture, rain or
mechanical impact. Try to keep the battery temperature between 0°C and
45°C at all times. If the battery is too hot or too cold, the product may
not work temporarily, even if it is fully charged. Do not attempt to charge
the device when the battery is damaged. Never insert metal objects
in any opening of the (USB) charging port. The rechargeable battery is
built into the device and can be replaced. Do not throw the battery into
the fire, otherwise it may explode. Batteries may also explode if being
damaged, please handle and disposal it according to local conditions and
regulations. After 3 months long storage, need to completely discharged
and recharge for at least 80%. The battery used in this device may
present a risk of fire or chemical burn if mistreated. Do not disassemble,
short contacts, heat above 60°C (140°F), or incinerate. Keep away from
children. Do not disassemble and do not dispose of in fire.
- Ensure that the device do not come into contact with heat sources, hot
objects or naked flames.
- Do not attempt to charge the device when the battery is damaged.
- Leaks from battery cells can occur under extreme conditions. If the
liquid gets on the skin, wash it immediately with soap and water. If the
liquid gets into the eyes, flush them directly with clean water for at least
15 minutes and seek medical attention.
Pay attention
- Please note that the charging port of the device should not have water
infiltration. Otherwise, it will cause a product failure.
- Do not charge or store the product in a place below 0gr or above 40gr,
otherwise the product performance will be reduced.
- It is a normal phenomenon that temperature of the charger rises
during charging.
- The product should be charged as soon as it is working to a low battery
level; it is forbidden to leave the product for a long period of time when
the battery is low, which may cause the lithium battery to over discharge
and fail to charge normal!
Operation and button use
Charging mode
Charge Fully before the first use! Use only the supplied USB-C to USB-A
charge cable and connect it with the TYPE-C charge input connection. You
can use any available USB power source / adapter with 5V DC 1A (1000mA)
minimum power. The full charging time is approximately 2-3 hours for the
lamps internal battery. The RED led light is indicating that the lamp is being
charged. When the RED led is OFF and GREEN is ON it means the battery
is fully charged. Remove charging cable from the device when ready and
disconnect the source/adapter from the mains power socket. The normal
use time is up till 24 hours when the batteries are fully charged but depends
on the settings, use, position way, PIR settings ON/OFF, light color mode and
other settings etc. This use time is tested based basic use/settings (factory
standard settings).
Battery status
Battery level can be checked by the FLINQ app at all times (except when
empty).
FlinQ Smart Outdoor Orion
Advertenties
