Advertenties
Beschikbare talen
Beschikbare talen
Manuel
EN
Installation
When the device is used on the ground
1
Preparations
Remove the device completely from the
plastic and remove all stickers and other
packaging materials.
When the heater is attached to the wall
Install the bracket
Mount the bracket on the back of the heater with the supplied screws.
Drill the holes
Drill the holes on either side of the wall, then insert the plastic expanded plugs and
attach the bracket to the wall with the screws.
Place the heater
Place the heater in a suitable position and ensure that the holes align with the bracket.
Tighten screws
Tighten the screws on the top of the bracket to make it fi xed and stable.
Put down device
2
Place the heater on a sturdy surface
such as a table. You can use a towel for
protection.
NB:
Please note that the product must be installed at least 15 cm from the fl oor and 50
cm from the ceiling if you hang it on the wall.
Attach the feet
3
Attach the 2 feet with the 8 supplied
screws. The holes for this are pre-drilled.
NB:
The device may only be hung horizontally. Vertical hanging is not possible, the
device will not work.
FlinQ Smart Indoor Panel Heater
Place the device
4
Place the device in the desired location.
Make sure that the device is always
placed horizontally.
Advertenties
