Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Installing the stove
The floor on which the stove is installed must be even
and horizontal. The stove may only be installed on an
adequate loadbearing floor. The stove can be stood on
a metal floor sheet or glass sheet to protect the floor-
ing.
If the flooring or carpet is inflammable, a stable and
non-combustible spark protection plate must be used.
This must extend 50 cm to the front and 30 cm to each
side beyond the edge of the combustion chamber
opening. Under the stove no spark protection plate is
required.
Assembly sequence
Since by the installation of the side cladding and the
OEC (manuals are included with the respective pack-
aging units) and by the connection change of the con-
nection support, the cover hood is removed, the reas-
sembly of the cover hood should only occur if all add-
on parts are attached.
● Remove the top cover.
● Unscrew the paneling for water connections of the
back panel (Fig. 1).
● Unscrew the back panel (Fig. 2).
● Slide the temperature sensor of the "Temperature
Difference Controller" into the right-hand sen-
sor pocket and secure it using the threaded screw
(Fig. 3).
● The connection of the flue Ø 150 mm may optional-
ly occur from above or from the back. The device is
delivered for connection installed from above.
If there should be a rear connection, it must be in-
stalled in the following steps:
- Break out the cover in the back panel.
- Replace the connector sleeve and the sealing
cover.
● Screw the pack panel.
● If required, assemble OEC.
● Install side cladding.
● Place the top cover back.
● Flue connection from the back: Close off the hole in
the top cover with the en-closed insertable cap.
Fig. 1 Paneling for water connections
Fig. 2 Unscrew the back panel
Fig. 3
Sensor pocket
for TAS
Sensor pocket for
temperature sensor
„Temperature Difference
Controller"
17
Advertenties
Hoofdstukken
Inhoudsopgave
