Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
5. Mode Button
6. Ready-to-start indicator
7. LED indicator "6 V"
8. LED indicator "12 V"
9. LED indicator "winter mode"
10. LED indicator "charging"
11. LED indicator "full battery"
12. LED indicator "wrong connection"
BEFORE USE
Preparation for battery charging
•
If necessary, remove the battery to be charged from the vehicle. First, always disconnect the earth cable
from the battery.
•
When charging the battery, make sure the room is ventilated properly.
•
Clean the battery contacts. Make sure that rust dustdoes not get in your eyes.
•
Fill all battery cells with distilled water up to the level marked by the manufacturer. By this, excessive
gas is pushed out of the cells. Do not exceed the mark when refilling the cells.
•
When charging batteries without cell caps (i.e. maintenance-free batteries), follow the instructions of
the manufacturer carefully.
•
Read the safety instructions given by the manufacturer carefully and check whether cell caps must be
removed during the charging process or whether they may stay closed; keep the charging current given
by the battery manufacturer.
•
Make sure that battery voltage corresponds with charger voltage.
•
ALWAYS follow the battery manufacturer's instructions concerning the battery power values.
Placing the battery charger
•
Place the battery charger in the maximum possible distance from the battery: as far as the DC secondary
cables can go.
•
Never place the charger over the battery to be charged:gases released from the battery may cause
corrosion and damage to the battery charger.
•
Make sure that electrolyte never spills on the battery charger when checking electrolyte thickness or
level in the battery.
•
Do not operate the device in closed venues or in places with insufficient ventilation.
•
Never place the battery charger on the battery.
•
Boat batteries (used on the sea) must be transported on land to be recharged.
9
Advertenties
Inhoudsopgave
