Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Installation
•
Connect one cable from the controller to the pump cable
and the other to the adapter cable. To make sure there is a
good connection slide the 2 plugs firmly into each other.
To make this easier you can soften the part that goes over
the other plug with your fingers.
•
Put the adapter's AC plug into the
power socket, the pump controller's LED
display will light up and the pump will start.
•
The controller is not waterproof and has to be
well amounted on the wall or the cabinet
with a screw. Damage caused by water is not
covered by warranty.
Operation
Speed up/down: Change the running speed of
•
the pump, to adjust the flow. The pump has
9 speed modes, corresponding displayed as
'01-09' in the LED display. '09' Is the maximum
speed of the pump.
•
Feeding ON/OFF: Press this button to stop the
pump for 10 minutes. After 10 minutes, the pump
will operate automatically. This function gives you
the time to feed your fish without getting food in
the filter. If you press the button again the pump
will work again.
Maintenance
•
Clean the pump monthly, depending on water and pollution conditions.
•
Regular cleaning extents the lifetime of the pump.
Disassembling sequence
•
Remove the base, turn the pump head counterclockwise
(Face the water inlet of pump) and dismantle it.
•
Take out the pump rotor.
Note: Please check whether the impeller works smoothly before installation. If not, please
adjust it accordingly.
Cleaning
•
Clean the chamber inside with the brush;
•
Clean the surfaces of the magnet and the impeller.
•
Clean the shaft, bearing and other space parts inside.
Wall mount
Speed down
Speed up
Feed On/Off
3
GB
Advertenties
Inhoudsopgave
