Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Commissioning the purifier UF 400
Pressurisation of the purifier:
Follow the pressurisation procedure described below carefully, this
will ensure that the purifier is completely purged and all trapped air is
removed. During this purge operation, the unit may briefly produce
some slightly coloured water, this is perfectly normal.
1) Open the pure water tap to the permanent flow position (lever
locked in the raised position).
2) Slowly open the purifier inlet valve until it is fully open.
3) Let the tap with purified water run for 6 minutes (this period of
time is essential for proper functioning).
4) Leave the pure water tap open and close the inlet valve for
approximately 1 minute.
5) Open the tap at the entrance to the purification device
again and let the water run from the tap with purified
water for at least 2 minutes.
6) Close the pure water tap.
7) Open the pure water tap to the permanent flow position and
allow it to run for 1 minute.
8) Purging and commissioning of your Cintroclear purifier is now
completed.
The card that hangs on your purifier reminds you that its maintenance
is essential to keep a good water quality with the passing years. The
maintenance of your
CINTROCLEAR UF 400
must be done once a year.
On this card bellow with
pre-printed calender you
can put a cross to mark the
next maintenance.
Your Cintroclear UF400 is
meant for domestic use.
The period of time
between 2 maintenances is
based thereon.
Maintenance
Advertenties
Inhoudsopgave
