Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
INSTALLATION OF THE CINTROCLEAR UF 400 WATER PURIFIER
Tools :
Your Cintroclear purifier can be connected very quickly and simply, all the hydraulic connections are carried
out using automatic push-in connectors that require no tools other than a cutter. Two other tools are required: a
screwdriver for mounting the purifier and a small drill fitted with a 14 mm drill bit for drilling the hole for
installing the pure water tap.
Positioning :
The purifier is usually positioned beneath the kitchen sink or in one of the nearby kitchen units, these places are
often the most simple to use. It may also be installed in any other position, as dictated by the layout of the
house: room next to the kitchen, cellar, laundry room, etc. The various accessories for connecting the water
supply and the small diameter of the inlet and outlet piping allow for many installation options. The purifier
must always be installed in a clean and easily accessible position that allows the meter to be read and
maintenance operations to be carried out simply.
IMPORTANT : for correct operation, the purifier must be installed and attached vertically. It must never
be operated when inclined or lying flat; this may give rise to operating problems.
Fixation :
The installation kit for your Cintroclear purifier contains two sets of fixing screws, allowing the unit to be
installed against a wall or in a kitchen unit for example. The shape of the attachment holes in the purifier
mounting plate allows it to be easily removed later for carrying out maintenance operations.
Piping:
Your Cintroclear purifier is equipped with automatic
connectors throughout. These connectors are very simple
to use and they are totally reliable. When cutting the
polyethylene pipes, take care to make clean, square cuts
without any burrs. Do not use any tool other than the
tube cutter, never use shears or cutting pliers, the
piping will not be cut cleanly and you risk damaging
the seal and causing leaks.
Attaching the pure water tap:
Position the components on the threaded tube : body
seal, rosace, plastic washer and rosace seal. Then pass
the threaded tube through the hole drilled previously in
the wash basin or work surface. Then place the lower
components on the threaded tube : st/st washer, lock
wascher, the nut, the internal cylindrical reinforcement,
the bicone and the nut (these last 3 components are put
on the blue outlet pipe) and tighten down.
Generally it will seal when tightened on hard by hand.
Nevertheless, if this is not sufficient it may be tightened
down lightly with a tool. In all cases, stop tightening
once it is sealed.
4
Advertenties
Inhoudsopgave
