Other Operations; Removing A Component; Replacing A Component - Duco IQ-unit Snelle Start
Verberg thumbnails
Zie ook voor IQ-unit:
- Gebruikershandleiding (2 pagina's) ,
- Gebruikershandleiding (2 pagina's) ,
- Gebruikershandleiding (2 pagina's)
Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
ENGLISH
6C.
Other operations
Activate 'Installer mode' in order to remove or replace a component.
This may be done via the component itself, please refer to the manual
for the component concerned.
Removing a component
Press once and hold the button of the component in order to remove it
from the network.
Replacing a component
Press briefly twice on the button of the component to be removed.
After that, press briefly once on the button of the new component. The
latter will take on all settings/connections within the network.
Tips
In order to remove all components from the network (e.g. in the event
of problems) you can press and hold 'INST' until the LED starts flash-
ing red. The IQ-unit will then reboot (around 15 seconds) and the LED
will stop flashing.
Use the Duco Network Tool to read out information from components.
Never pair more than one system with RF components at the same
time.
98
Advertenties
Hoofdstukken
Inhoudsopgave
