Installing Components - Duco IQ-unit Snelle Start
Verberg thumbnails
Zie ook voor IQ-unit:
- Gebruikershandleiding (2 pagina's) ,
- Gebruikershandleiding (2 pagina's) ,
- Gebruikershandleiding (2 pagina's)
Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
ENGLISH
6B.
Go through the following steps to pair components with the IQ-unit.
Activate 'Installer mode' by tapping 'INST' on the IQ-unit. The LED
1
will flash green rapidly.
For zonally controlled systems only: Tap once on the feed-through
2
component to pair it with the IQ-unit so the LED flashes green
slowly. Tap again so the LED starts to flash rapidly. Underlying
components can now be added in this zone.
Add control components* by tapping once on the component to be
3
paired. The LED will start to flash green rapidly.
Add any window ventilators* by tapping once on the component to
4
be paired. The LED will flash green slowly.
For zonally controlled systems only: Repeat steps
5
until all remaining components in the current zone are paired. Exit
the current zone next by tapping the feed-through component from
step
2
For zonally controlled systems only: Repeat steps
6
inclusive for the remaining zones.
Once all components have been paired, 'Installer mode' can be
7
deactivated by tapping 'INST' on the IQ-unit.
Please refer to the manual with the components for more detailed
information.
* NB: only RF components can be paired under an Intelli Air Valve.
94
Installing components
once more. The LED will flash green slowly again.
and
3
4
to
2
5
Advertenties
Hoofdstukken
Inhoudsopgave
