Advertenties
Beschikbare talen
Beschikbare talen
Operating Instructions
Note
Various types of sensors can be connected to the device (please refer
to the relevant operating instructions for your chosen sensor).
• Sun sensor (Sun sensor for sun and wind control device Centronic Sensor-
Control SC41)
• Wind sensor (wind sensor for sun and wind control device Centronic Sensor-
Control SC21/SC51/SC71)
• Sun and wind sensor (sun and wind sensor for sun and wind control device
Centronic SensorControl SC61/SC81)
Manual/Automatic sliding switch
In the "MANUAL" mode, only manual control commands and alarm signals are
executed (e.g.: by pressing RETRACTION, STOP, EXTENSION buttons and wind
alarm).
When the sliding switch is set to "AUTO", automatic control commands are car-
ried out (e.g. Automatic sun protection function, ...)
Alarm signal control light
If the alarm signal control light is illuminated, this indicates an alarm signal. An
alarm signal is a continuous switching signal at the group control inputs which
lasts for more than 5 seconds.
Group control
Group control refers to the simultaneous control of several drives.
Operating mode
The current wind and/or sunlight settings can be seen in the display.
OK button
Press the OK button to store the current values displayed.
To activate the test mode, press the OK button and hold for 5 seconds. In addi-
tion, the MANUAL/AUTO sliding switch must be set to AUTO.
34
Sensors
Explanations
Advertenties
Hoofdstukken
