Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Initial use
Always activate switch lock
lock the trigger
the product from the mains before
starting any works on the product.
Adding staples
Turn the product over.
Squeeze the release button
Then pull out the push rod
(see Fig. B).
4
Add staples to the magazine
After adding staples, slide the push rod
back to the magazine
Release button
3 a
place with the magazine
Note: Use the window on the fill indicator
to check if the magazine
7
use both fill indicators to check whether there are
still staples in the magazine.
Adding nails
Turn the product over.
Squeeze the release button
Then pull out the push rod
(see Fig. B).
4
Follow icon
add nails to the magazine
After adding nails, slide the push rod
to the magazine
button
must click and lock in place with
3 a
the magazine
4
Note: Use the window on the fill indicator
check if the magazine
10 GB/IE/NI
1
and disconnect
2
(see Fig. B).
3 a
from magazine
3
(see Fig. C).
4
till it is closed.
4
must click and lock in
properly.
4
5
is empty. You can
4
(see Fig. B).
3 a
from magazine
3
shown on push rod
3
(see Fig. D).
4
back
3
till it is closed. Release
4
properly.
7
is empty.
4
Functions
Stapling and nailing
to
Press down switch lock
right to left to unlock position .
Press the safety contact
piece (see Fig. E).
Squeeze the switch trigger
the product against the work piece to drive
a staple / nail into it.
Note: Hold product firmly and press on work
surface before firing to ensure complete penetra-
tion of the staple / nail.
3
Clearing jammed
staples or nails
or
starting any works on the product.
Open the magazine
push rod
3
Remove the jammed staple or nail from the
magazine
Determining the staple length
and
Consider two factors when determining the
correct staple length:
- the thickness of the material being fastened
- the composition (hardness) of the material
being fastened.
6–8 mm staple or 14–15 mm nail in length will
to
typically suffice when driving into plywood and
fiber board.
8–14 mm staple or 14–15 mm nail in length will
typically suffice when fastening into softwood
such as pinewood.
completely from
1
into the work
6
whilst holding
2
Always activate switch lock
lock the trigger
and disconnect
2
the product from the mains before
and pull out the
4
.
.
4
to
1
Advertenties
Hoofdstukken
Inhoudsopgave
