Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
EN
NOTICE – Risk of Damage to
Material and Property
■
Only connect the device to a plug
socket that is properly installed and
matches the technical data of the
device. The plug socket must also be
readily accessible after connection so
that the connection to the mains can
quickly be isolated.
■
Make sure that the connecting cable
is not squashed, bent or laid over
sharp edges and does not come into
contact with hot surfaces (this also
applies to the hot surfaces of the
device!).
■
Only use heat-resistant utensils to
place and remove the food. Keep
metal objects or other sharp objects
away from the device. These objects
could damage the non-stick coating
of the grill plates. We recommend the
use of heat-resistant kitchen utensils
made from wood or plastic.
■
Switch off the device and pull the
mains plug out of the plug socket
if an error occurs during operation,
when there is a power cut or before a
thunderstorm.
■
Never pull or carry the device by the
connecting cable.
■
When you pull the mains plug out
of the plug socket, always pull on
the mains plug and never the mains
cable!
■
Protect the device from other heat
sources, naked fl ames, sub-zero tem-
peratures, persistent moisture, wet
conditions and impacts.
■
Use only original accessories from the
manufacturer in order to guarantee
that there is no interference that may
prevent the device from working and
to avoid possible damage.
14
09550_Inlay_DE-EN-FR-NL_A5.indd 14
09550_Inlay_DE-EN-FR-NL_A5.indd 14
BEFORE INITIAL USE
There may still be some production
residues on the device. To avoid harmful
effects to your health, clean the device
thoroughly before you fi rst use it and
then heat it up for a few minutes. To
do this, follow the instructions in the
"Cleaning and Storage", "Setting Up the
Device" and "Use" chapters.
When the device is fi rst used,
production-related additives (e.g.
grease) may cause a small amount
of smoke and / or an odour to be
produced. This is normal and not
a device defect.
SETTING UP THE DEVICE
Please Note!
■
Do not place the device below kitch-
en wall units or similar cupboards. The
rising steam could cause damage to
them!
■
The device may only be operated in a
horizontal position, never on its side
or tilted.
1. Always set up the closed device with
a clear space at the sides (at least 20
cm) and clear space above it (at least
30 cm) on a fl at, solid and heat-re-
sistant surface that is resistant to fat
splashing.
2. Insert the grill plates (4 and 9) into
the device: To do this, place one grill
plate at a slight angle with the recess-
es into the locking lugs (3 and 8) on
the device and press down. The grill
plate must engage audibly (Picture C).
3. Insert the fat collecting tray (6) into
the bottom of the housing.
02.06.2020 15:23:14
02.06.2020 15:23:14
Advertenties
Hoofdstukken
Inhoudsopgave
