Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
GB
IE
NI
Screws:
Drilling:
2. Start with a lower torque step and in-
crease according to requirement.
Torque adjustment should only be
performed in standstill mode.
Reaching the preset torque limit pro-
duces a noticeable rasping sound.
This sound is caused by the slip clutch.
Tool change
1. Rotate the keyless chuck (1) towards
RELEASE
until the drill chuck aperture
(11) is large enough to accommodate
the tool.
2. Push the tool as far as possible into the
keyless chuck (1).
3. Turn the keyless chuck towards
order to clamp the tool.
4. To remove the tool again, rotate the
keyless chuck (1) and pull out the tool.
Keyless drill chuck
removal
To use the bitholder (16), you must remove
the keyless chuck (1).
1. Hold the keyless chuck (1) tightly from
the front. Pull or push the drill chuck
ring (2) in the direction of the keyless
chuck (1).
2. This unlocks the keyless chuck (1) and it
can be pulled off from the front.
3. In order to put the keyless chuck (1)
back in position, pull the drill chuck
ring (2) in the direction of the keyless
chuck. Push the keyless chuck (1) on as
far as it will go.
12
Steps 1 - 19
Step .
GRIP
When setting the keyless chuck, a
25 mm bit may remain in the bit
holder (16).
If the keyless chuck (1) does not
engage automatically, turn the drill
chuck ring (2).
Using the bitholder
After removing the keyless chuck (1) you
can use the bitholder (16).
There is a magnet bit holder
(
housing.
You can attach one bit at a time to
the magnetic bit holder.
1. Insert a suitable 6-point bit in the
bitholder (16). Because of the 6-point
in
bit holder, it may be that you need to
rotate the bit slightly.
2. Slide the bit right into the bitholder
(16). The bit is held firmly by the duct
and the magnetic bitholder.
3. To remove the bit, simply remove the bit
from the bitholder (16).
Switching on/off
By using the on/off switch (7) you can
progressively control the speed. The longer
you push the on-off button, the higher the
speed.
1. Press the on/off switch (7) to start the
device. The LED work light (8) lights up
during operation.
2. To turn it off, release the on/off switch
(7). When you move the direction
switch (6) to the middle position,
the device is secured against being
switched on.
17) on the left and right of the
Advertenties
Hoofdstukken
Inhoudsopgave
