Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
MANUAL MODE
ADJUSTING THE HEIGHT OF THE FLAMES MANUALLY, ONCE THE PILOT HAS BEEN LIT.
•
HIGHER
Press
(
flames smaller or to switch the fire to the
sign will appear in the upper left corner of the display on the handset display.
•
When the gas valve has reached its maximum position (open or closed), the LED of the receiver will
start blinking, indicating that the highest or lowest position is reached.
AUTOMATIC MODE 'AUTO' in display
Use this mode to set the desired temperature that you would like the room to stay at.
•
Press and hold the AUTO button until the display flashes.
•
Press either of the buttons ( ) and ( ) to set the desired temperature.
•
Wait a few seconds until the set temperature stops flashing or press AUTO to switch to AUTO MODE.
TIMER 'TIMER' IN DISPLAY
Use this mode to switch the Stealth on and off automatically at the times set.
If the timer mode is switched on, temperature control is done in the same way as in the AUTO mode. As soon as
the 'heating cycle off' time is reached, the Stealth will switch to the
PILOT ON position and there is no temperature control. This minimizes battery consumption.
SWITCHING THE FIRE OFF
We recommend to switch the fire off using the ( ) button; the transmitter will then not be active and will not
use up any energy from the batteries.
By pressing either of the buttons ( ) and ( ), you will reach "manual operation", from any other mode.
CHANGING THE BATTERIES
If "BATT" appears in the top right corner of the display, or if the LED light on the receiver becomes less bright,
the batteries needs to be changed.
AUTOMATIC SAFETY SWITCH-OFF:
If the receiver does not receive any signal during a 2 hour period, the unit will switch to the pilot light mode
automatically and will switch on again as soon as a new signal is sent.
This may happen for example if the remote control was accidently removed from the property.
Required batteries:
) to start the fire or to make the flames higher. Press
PILOT ON
1x 9v, alkaline for the remote control and
4x AA, 1,5v penlight for the receiver.
LOWER
(
position. On pressing these buttons, the "send"
) to make the
28
Advertenties
Hoofdstukken
Inhoudsopgave
