Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
3.3 REMOTE CONTROL OPERATING INSTRUCTIONS
The two large buttons on the remote control
hand-set are used to operate the main burner.
The two smaller buttons are for AUTO and TIMER.
Instructions for their use follow.
SETTING THE DISPLAY
After fitting the batteries in the receiver and the hand set, the following options are available:
Adjustment of the digital display (from 'DEGREES F & 12 HOUR' to 'DEGREES C & 24 HOUR' and vice
versa)
•
Press the buttons AUTO and TIMER at the same time until the display blinks.
•
Now you can switch from F to C and vice-versa by pressing the AUTO button.
•
The display will return to "manual operation" after a short time.
SETTING THE TIME
•
Press the buttons AUTO and TIMER at the same time, the indications on the screen start to blink.
•
To set the time, the
To return to manual operation, you need to wait several seconds or push the TIMER button.
SETTING THE DESIRED AUTOMATIC TEMPERATURE
•
Press the AUTO button until the "temperature" indication starts to blink.
•
Then set the desired temperature by means of the
•
After that, wait or press AUTO to get to the automatic mode.
The sensor in the remote control measures the temperature in the room. The receiver
on the stove compares the room temperature with the pre-set temperature and if necessary, adjusts the height of
the flames automatically.
PROGRAMMING THE TIMER FUNCTION
•
Keep TIMER button pressed until indication P1 starts to blink.
•
Then set the switch-on time by means of the buttons
•
Press TIMER again, until P1 appears. Then the switch-off time can be set.
•
By pressing TIMER once again, the times for the second program, P2 can be set.
•
The set times must be confirmed by pressing TIMER again.
•
Outside the programmed times the symbol will appear.
button must be pressed to set the hours. The
HIGHER
AUTO
TIMER
LOWER
button will set the minutes.
or
button.
for hours and
for minutes.
27
Advertenties
Hoofdstukken
Inhoudsopgave
