Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
TIPS
• High ambient temperatures have a negative effect on energy use. Keep the refrigerator in a position away from direct sunlight or
other sources of heat.
• Keep ventilation openings free. Clogged openings lead to higher use of energy.
• Try not to open the door too often, especially when the weather is wet and hot. Once you open the door, mind to close it as soon as
possible.
• The space between the shelves and the rear wall of the refrigerator compartment must be unobstructed to allow the cool air to
circulate. Therefore don't place any food items against the back.
• Turn the thermostat to a lower setting when the circumstances allow it.
• Before storing fresh cooked food, make sure the food has cooled at least to room temperature.
• Ice and frost layer increase energy consumption, so clean the appliance as soon as the layer is 3 to 5 mm thick.
• If the gasket is damaged or if it turns out that the sealing is poor, the energy consumption is substantially higher. To restore
efficiency, replace the gasket.
• Keep the condensor on the rear wall always clean, free of dust or any impurities.
• Always consider the instructions, otherwise the energyconsumption is substantially higher.
7
repositioning the door - not possible with this model
It is not possible to change the opening direction of your fridge door, because of the handle which is installed on the front surface of
the door.
8
troubleshooting
If your appliance is not working properly, it may be a minor problem, therefore check the following:
Problem
Appliance is not functioning; light
does not work.
Temperature inside the
refrigerator is too high or too low.
Water is running out of the
refrigerator.
Appliance is excessively noisy.
The inside light is not working.
Note: gurgling and hissing noises due to expansion in the refrigerant circuit are normal.
20
•
English
Cause
- Appliance is not plugged in;
- There is a power failure;
- The thermostat is set on ●.
Thermostat has been set
incorrectly.
Air circulation vents are blocked.
Drain outlet is blocked.
Has the appliance been installed
correctly?
Are the pipes at the back
touching or vibrating?
Lamp is defective.
Solution
- Plug the appliance in;
- Check the fuse box;
- Set the thermostat on setting 1-5.
Set the thermostat correctly.
Clean the ventilation openings.
Clear the drain outlet with a skewer.
Check the installation.
Check it and move the appliance forwards.
Contact the customer service department.
Advertenties
Inhoudsopgave
