Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
d) Reset the mount
If the mount cannot be adjusted to the highest position (0° against the ceiling) or the lowest position:
1. Disconnect then reconnect the power supply.
2. Press and hold the OK button (approx. 5 sec) until the mount retracts to the highest position.
3. The mount has now been reset.
e) Reset the tilt range for pitched ceilings
The default folding tilt range is 0 to -75º. If you are mounting it to a pitched ceiling, please reset the tilt range.
1. Reset the mount. Refer to previous section "Reset the mount".
2. Press the
,
, and OK buttons to set the proper position against the ceiling.
3. Press and hold the mem1 button until it beeps once.
4. Step 2 should be repeated 5 times. The unit will emit a long beep to indicate success.
Steps 2 and 3 should be completed within 2 minutes otherwise you will need start again from step 1.
f) Manual mode
If the mount is manually moved, it will automatically return to the minimum position against the ceiling (0°).
g) Matching the remote controller and box.
1. Connect the mount to the power supply.
2. Insert a small tool into the control box and press the matching button once. The box will emit a beep to indicate
that is is ready for matching.
3. Press the SET button on the remote. The box will beep repeatedly for approximately 10 seconds to indicate the
remote control is being matched. When the beeping stops it means that matching is complete.
The mount can be matched with up to 20 remote controllers.
To reset all matched controllers, press and hold the matching button for approximately 5 sec. The unit will
beep twice to confirm all matched controllers have been released.
34
Advertenties
Hoofdstukken
Inhoudsopgave
