Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
eNet
Radiografische stuureenheid 1-10 V
Switch-off warning
Priority, lock-out protection
Priority, restraint
Priority, wind alarm
Priority, sun protection
Priority, twilight
Switch off brightness overs-
hoot
82581013
J:0082581013
On, Off
Basic setting: Off
0...4
Basic setting: 1
0...4
Basic setting: 2
0...4
Basic setting: 3
0...4
Basic setting: 0
0...4
Basic setting: 0
On, Off
Basic setting: On
9/11
If the switch-off warning is
active, then, during switch-off,
the systems dims to minimum
brightness within 30 seconds
and only then switches off. If
the parameter "Dim down
ramp" is configured as longer
than 30 s, then the length of
the dim down ramp is applied.
If, during the dim down opera-
tion, another command is
given, e.g. switch on or scene
recall, then the switch-off
warning stops and the com-
mand is executed. A switch-off
command restarts the time for
the switch-off warning.
Note: The set time apply to
operation using radio transmit-
ters. The device is switched
immediately when the Prog
button is pressed.
Specifies the priority for
recalling and removing a sce-
ne of type Lock-out protection
for the channel.
Note: 1 is the highest priority
and 4 the lowest. 0 means no
priority.
Specifies the priority for
recalling and removing a sce-
ne of type Forced position for
the channel.
Specifies the priority for
recalling and removing a sce-
ne of type Wind alarm for the
channel.
Specifies the priority for
recalling and removing a sce-
ne of type Sun protection for
the channel.
Specifies the priority for
recalling and removing a sce-
ne of type Twilight for the
channel.
Allows automatic switch-off
according to the brightness. If
the parameter is On, then the
light controller switches off
automatically when the
brightness setpoint is greatly
exceeded.
Note: This parameter is not
yet active, as a light controller
has not yet been implemen-
ted.
13.03.2014
Advertenties
Inhoudsopgave
