Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
eNet
Radiografische stuureenheid 1-10 V
Switch on brightness unders-
hoot
Minimum brightness
Maximum brightness
Hotel function
Operating hours
Information window
In the Information window, the load can be controlled and the information about the device can
be displays.
Display value
82581013
J:0082581013
On, Off
Basic setting: Off
1...67 %
Basic setting: 5 %
75...100 %
Basic setting: 100 %
On, Off
Basic setting: Off
0...65535
Basic setting: Current value
Explanations
10/11
Allows automatic switch-on
according to the brightness. If
the parameter is On, then the
light controller switches on
automatically when the
brightness setpoint is greatly
undershot. We recommend
only using the parameter in
connection with the parameter
"Switch-off on brightness
overshoot".
Note: This parameter is not
yet active, as a light controller
has not yet been implemen-
ted.
Specifies the minimum setta-
ble brightness.
Note: If parameters or scene
values are set to a level lower
than the minimum brightness,
then the system will dim to
minimum brightness.
Specifies the maximum setta-
ble brightness.
Note: If parameters or scene
values are set to a level higher
than the maximum brightness,
then the system will dim to
maximum brightness.
If the hotel function is activa-
ted, the system will dim to 20
% brightness when a switch-
off command is made. Switch-
off is only possible with a for-
ced position command.
Note: If the minimum
brightness is set to greater
than 20 %, then the system
dims to the set minimum
brightness when the hotel
function is activated.
The time is counted during
which the load is physically
switched on (relay contact clo-
sed).
This parameter can be reset to
"0", for example after exchan-
ging the load.
The Reset button is used to
reset the counter to "0". The
device must be programmed
to apply the change.
13.03.2014
Advertenties
Inhoudsopgave
