Download Inhoudsopgave Inhoud Print deze pagina

Jung eNet FM ST 50 UP Bedieningshandleiding pagina 8

Radiografische stuureenheid 1-10 v
Inhoudsopgave

Advertenties

Beschikbare talen

Beschikbare talen

eNet
Radiografische stuureenheid 1-10 V
Dim down ramp
Dimming adjustment time
Run-on time
Behaviour after the end of the
disabling function
Behaviour on voltage return
Brightness on voltage return
82581013
J:0082581013
0 s ... 24 h
Basic setting: 0 s
1...60 s
Basic setting: 4 s
0 s ... 24 h
Basic setting: 0 s
On
Off
no change
Last value
Basic setting: No change
On
Off
Last value
Configured brightness
Basic setting: Off
0...100 %
Basic setting: 100 %
8/11
Time until reaching minimum
brightness. The light is dim-
med to minimum brightness
and then switched off.
Only applies to switch-off with
transmitters (short operation).
If scenes are recalled or swit-
ching uses logic modules, the
system switches off directly.
Time from minimum
brightness until reaching maxi-
mum brightness (dimming
speed).
As soon as a run-on time has
been entered, the actuator will
no longer remain on perma-
nently, but only for the length
of the run-on time. The run-on
time is restarted if actuation is
repeated. This parameter is
directly connected to the
"Manual switch-off of run-on
time" parameter.
Note: The set time apply to
operation using radio transmit-
ters. The device is switched
immediately when the Prog
button is pressed.
Behaviour of the output when
a block is removed.
Defines the behaviour of the
output after voltage return.
Brightness value, set by the
output after voltage return
(mains voltage). The parame-
ter "Behaviour after voltage
return" must be set to "Confi-
gured brightness".
Note: If the value is above the
set maximum brightness or
below the minimum
brightness, then the system
will switch to the appropriate
limit value.
13.03.2014

Advertenties

Inhoudsopgave
loading

Inhoudsopgave