Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
EN
Before first use
1. Remove any possible films, stickers or transport protection from the device. Never
remove the rating plate and any possible warnings.
2. The device may have production residues stuck to it. To prevent health risks, clean
the device thoroughly before its first use and then heat up for a couple of minutes.
Follow the instructions in the chapters "Cleaning and storage", "Assembly" and "Use".
L
During initial startup, production-related additives (e. g. grease) can lead to slight
smoke and / or odour development. This is normal and not a defect of the device.
3. Clean the device again.
Assembly
Please note!
■
Always set up the device with a clear space at the sides (at least 20 cm) and clear
space above it (at least 30 cm) on a flat, solid and heat-resistant surface that is
resistant to splashing fat.
1. Place the bowl (9) onto the base (6) and carefully press it down.
3. Place the locking ring (1) onto the protective edge (2) and press it on firmly on the
lower border of the protective edge. You must hear and feel it engage.
4. Place the protective edge with the locking ring onto the bowl. Press the locking ring
down firmly on the upper edge of the bowl. You must hear and feel it engage.
Perform the steps in reverse to dismantle the device.
07329_06532_DE-EN-FR-NL_A5_V5.indb 16
07329_06532_DE-EN-FR-NL_A5_V5.indb 16
16
2. Rotate the bowl anticlockwise. Make sure that the locking
lugs on the bowl fit securely in the metal locks on the
base. You must feel them engage.
5. Place the sugar container (3) onto the base. Make
sure that the slip-on sleeve on the bottom of the sugar
container sits securely on the axis of the base.
25.07.2022 16:59:18
25.07.2022 16:59:18
Advertenties
Hoofdstukken
Inhoudsopgave
