Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
2. Set the ON/OFF switch to "0".
3. Wait until the drill bit has fully stopped.
4. Close the water supply.
5. Disconnect the product from the power supply.
To replace the drill bit
WARNING: Pull out the plug from the mains
socket before you replace the drill bit.
WARNING: Use protective gloves. Let the
product become cool before you remove the
drill bit. The drill bit and the adjacent area
are very hot after operation.
WARNING: Only use diamond drill bits that
are approved for your product. Speak to
Discount-equipment for more information.
1. Make sure that you have got a new drill bit, the
supplied wrench and water resistant grease.
2. Lock the spindle axle with the wrench.
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.
WARNING: To prevent injury, disconnect the
power cord before you do maintenance.
Maintenance
Make sure that the nuts and screws are tight.
Make sure that the ON/OFF switch operates correctly. Refer to
To do a check of the ON/OFF switch on page 7 .
1320 - 001 - 14.10.2019
3. Turn the drill bit clockwise to remove it.
4. Lubricate the spindle shaft thread with water
resistant grease.
5. Turn the drill bit counterclockwise to install it. Tighten
fully.
Maintenance
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
X = The instructions are given in this operator's manual.
Before each
CAUTION: Do not hit the product to
remove the drill bit. There is a risk of
damage to the gearbox and the drill
stand.
After each use
use
*
X
Each 300 h
11
Advertenties
Hoofdstukken
Inhoudsopgave
