Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
3
using the appliance for the first time
Before using the appliance for the first time, you should proceed as follows: carefully unpack the appliance and remove
all packaging material and any promotional stickers. Keep the packaging (plastic bags, polystyrene and cardboard) out
of the reach of children. After unpacking the appliance, check it for external damage that may have occurred during
transport. Place the appliance on a sturdy, flat surface and make sure there is enough space all around for sufficient
ventilation. A minimum space of 10 cm is required between the appliance and the surrounding walls. In this way
the appliance is able to release heat properly, cool well and function in an energy efficient way. You can use the adjustable
feet to level the appliance. Do not place the appliance near heat sources such as central heating or a stove. Do take note
of the climate class of the appliance. When placed in a room that is too cold, the refrigerator will not function properly.
After placing the appliance, leave it for at least 3 hours before inserting the plug in the socket.
First clean the interior of the appliance. Use warm soapy water with, for instance, washing-up liquid, all-purpose
cleaner or soda. Wipe the inside of the appliance after cleaning with clean water and properly wipe everything dry.
Leave the appliance to dry for 1 to 2 hours.
ALIGNING THE DOORS
When the doors of the appliance have been aligned correctly in relation to the top side of the appliance, it is possible
to adjust the height. If necessary, take the following steps:
Important: the maximum height adjustment is 5 mm.
Loosen the lock nut by two clockwise turns using an open-end wrench. Now it is possible to turn the adjusting nut in order
to move the door up or down. When the door is in the correct position, tighten the lock nut again, anti-clockwise.
adjusting nut
fixed shaft
not even
right
adjusting nut
open-end wrench
lock nut
When the door is too low:
Open the door, use an open-end wrench to loosen the lock nut and turn the adjusting nut anti-clockwise to move the door
upwards. When the door is in the correct position, tighten the lock nut again, anti-clockwise.
When the door is too high:
Open the door, use an open-end wrench to loosen the lock nut and turn the adjusting nut clockwise to move the door
downwards. When the door is in the correct position, tighten the lock nut again, anti-clockwise.
22
•
English
Advertenties
Inhoudsopgave
