Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
CHANGING A LED SPOT
When a LED spot of the cooker hood is broken, you can replace it yourself. Follow these steps:
• Unplug the appliance or remove the connector fuse.
• Remove the grease filters and push the spot holder from the inside downwards - figure 1.
• Turn the broken LED clockwise out of the holder - figure 1. Replace the broken LED with a matching type (3.0 W, LED spot).
• Fit the new LED counter clockwise in the holder and release the holder - figure 2. It will automatically adjust to the right position.
• Replace the grease filters and plug the appliance in.
1
2
6
troubleshooting
What to do in case of a malfunction? In most cases, you will be able to correct these faults easily yourself. Please check the solutions
below before contacting the Inventum service department.
The motor is not running
• Is it plugged in correctly?
• Is there a power outage?
• Check the electrical installation.
The performance of the cooker hood is not correct and makes more nois.
• Is the diameter of the exhaust-air pipe correct?
• Is the duct blocked?
• The diameter of the duct must be 120 mm. A smaller diameter can negatively influence the suction of the motor.
• Are the grease filters clean?
• Is there enough air supply to replace the extracted air?
22
•
English
Advertenties
Inhoudsopgave
