What To Do If; General Conformity Declaration - Becker Centronic SensorControl SC811 Montage- En Gebruiksaanwijzing
Zon-windsensor draadloos
Verberg thumbnails
Zie ook voor Centronic SensorControl SC811:
- Montage- en gebruiksaanwijzing (44 pagina's) ,
- Gebruiksaanwijzing (36 pagina's)
Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Assembly and Operating Instructions
Problem
Drive is not functioning.
Transmission control
light is on
Automatic control com-
mands are not carried
out.
The system does not
automatically extend
when should the sliding
switch be set to "S"
The system does not
extend in response to a
manual command when
the sliding switch is set
to "H" or "S".
System is opening when
raining in spite of rain
sensor.
General conformity declaration
Becker-Antriebe GmbH hereby declares that the device Centronic SensorCon-
trol SC811 complies with the basic requirements and other relevant regulations
of the EC Directive R&TTE 1999/5/EC.
For use in the following countries: EU, CH, NO, IS, LI
Subject to technical changes without notice.
18
What to do if ...?
Cause
1. Receiver is outside
of the radio operating
range.
2. The SC811 has not
been programmed into
the receiver.
The sliding switch of the
hand-held/wall trans-
mitter is set to manual
mode "H".
1. The sunlight thresh-
old value has not been
reached.
2. The wind thresh-
old value is has been
exceeded.
The wind threshold
value of the transmitter
has been exceeded.
Wrong connection of
rain sensor .
Remedy
1. Reduce the distance
to the receiver.
2. Programme the
SC811.
Adjust the sliding switch
of the hand-held/wall
transmitter to automatic
mode "S".
1. Adjust sunlight
threshold value using
the transmitter.
2. Wait until wind
abates.
Wait until wind abates.
Verify wiring.
Advertenties
Inhoudsopgave
