EN
6.10 Start wash programme
Press "Start/Pause" button (Fig. 6-8) to start. The LED stops flashing
and lights up continuously.
Appliance operates according to present settings.
Changes are only possible by cancelling the programme.
6.11 Interrupt / cancel wash programme
To interrupt a running programme press gently "Start/Pause". The LED above the button
is flashing. Press it again to resume operation.
To cancel a running programme and all its individual settings:
1. Press "Start/Pause" button to interrupt the running programme.
2. Turn the knob directly to select a new program and start it.
3. When the water level is lower than the water level set by the new program, water
will enter.
6.12 After washing
Note: Door lock
For safety reasons the door is locked partially during the washing cycle. It is only pos-
sible to open the door at the end of the programme or after the programme was can-
celled correctly (see description above).
In case of high water level, high water temperature and during spinning it is not pos-
sible to open the door; Loc
1. At programme cycle end END is displayed.
2.
3. Remove laundry as soon as possible to go easy on it and to prevent more wrinkling.
4.
5. Unplug the power cord.
6. Open the door to prevent formation of moisture and odours. Let it open while not used.
Note: Standby-mode / energy -saving mode
The switched on appliance will go into standby-mode if it will not be activated within 2
minutes before starting the programme or at the end of programme. The display
switches off. This save energy.
6.13 Activate or deactivate the buzzer
The acoustic signal can be deselected if necessary:
1. Switch on the appliance.
2. Select the
M
X I
. 3
Press the "Anti-crease" button and "Temp." button and "Extra Rinse" button at the
same time for about 3 seconds. "BEEP OFF" will be displayed and the buzzer will be
deactivated.
For activating the buzzer touch these three buttons at the same time again. "bEEP ON"
will be displayed.
is displayed.
l -
programme.
6-Daily use
6-8
17