CLEANING AND MAINTENANCE
Check and make sure the drain plug must be closed well. Fill the water reservoir with
clean water, then hold and press the"ON/OFF" key for 10 seconds, the pump will start to
pump water and keep running for 15 minutes, and it will enter into standby condition after
running for 15 minutes, finally, open the drain plug and empty the water
To keep your ice tasting fresh and your ice maker looking great, we recommend cleaning
your ice maker once per week.
1.
Stop the ice-making cycle by pressing the ON/OFF key, unplug the ice maker from the
wall outlet and allow it to warm up to room temperature.
2.
If residual water is found in the ice tray, gently push the ice tray back so that all water
drains into the water reservoir.
3.
Move the appliance forward to a position 75mm away from the working table and
open the drain plug to drain out excess water.
4.
Remove the ice basket.
5.
Clean the evaporator by following the operation as below: pour the clean water into
the ice maker and run it to make ice for three cycles, and then empty the ice and
water in the ice maker.
6.
Clean the ice maker interior with a soft cloth soaked with warm water and vinegar,
then rinse with clean water and then drain all the water.
7.
Replace the drain plug well in position. Wash the ice basket and ice scoop in warm
soapy water. Rinse and dry.
8.
Clean the exterior of the ice maker with a soft damp cloth. Use a mild dishwashing
soap, if necessary.
Note: Do not use organic solvent, boiled water, detergent, strong acid and strong
alkali etc. for cleaning.
9.
Please empty the water reservoir and dry it for storage if the ice maker is not used for
a long time.
In the event of an abnormal grounding system outside the appliance, the use of the ice
machine should be immediately discontinued.And unplug its power plug or disconnect all
connections with the power supply circuit, and contact the manufacturer's maintenance
staff to deal with. Note: If the problems listed above are caused by the ice machine itself,
the professional should be asked to repair them.If failure can not be eliminated, please
contact after-sales service department, please do not disassemble at will.
2024-01-23 BluMill Ice Cube Maker ManualV02.indd 9
2024-01-23 BluMill Ice Cube Maker ManualV02.indd 9
EN
9
20-02-2024 14:29
20-02-2024 14:29