Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
BEFORE FIRST USE
EN
1.
Please ensure the ice maker is level and on a stable table or platform to avoid
malfunction.
2.
The incline angle of the ice maker cabinet should not exceed 45°during transportati-
on or use. Do not turn the ice maker upside down. Doing so could cause the com-
pressor or refrigerating system to operate incorrectly. Please allow time for the fluids
in the compressor to settle after the ice maker is moved or transported. Before using
the ice maker for the first time, please wait for 2 hours after the unit has been leveled
and positioned in the proper place.
3.
Unpack the appliance, then check and make sure that all the accessories including
ice basket and ice scoop etc. are complete. Please contact with the client service
department if some accessories are missed.
4.
The appliance must be placed on a dry and level surface with sufficient ventilation,
far from heat sources such as ovens, heaters and corrosive gases.Leave an about
8-inch clearance on all sides of the ice maker for proper ventilation.
5.
Do not fill the water reservoir with hot water. This may damage the ice maker. It isDo
not use the appliance at a very cold environment (lower than 5
6.
Clean the appliance by following the operation of "CLEANING AND MAINTENANCE"
before operate.
USING YOUR ICE MAKER
1.
Open the top cover, take out the ice basket and add water to the tank to keep the
water level below the
2.
Press the on/off button on the control panel to start making ice.
3.
Press the settings button to select the size of ice, if the room temperature is below
15 degrees C, we recommend you choose small ice to prevent even ice.
4.
Each ice-making cycle lasts from 6 to 13 minutes, depending on the size of the cho-
sen ice and the room temperature,
5.
After the ice machine starts, check the water level in the tank frequently. If the pump
fails to pump water, the ice maker will automatically shut down.The water shortage
indicator light shows that there is a shortage of water. At this time, add water to the
water tank and press on/Key to start ice making again.
6.
If the ice in the ice basket is full, it will stop making ice automatically and the full ice
lamp will light up. When the ice position is below the infrared detection position, the
machine will work again and the light will be too strong, which may affect the full ice
function.
7.
It is recommended to change the water every 24 hours to keep it clean. If the ice
machine is not used for a long time,please drain the remaining water from the tank.
8.
In standby, press on/key for 5 seconds until the ice is full and the water shortage
lamp flashes in turn. The automatic cleaning function starts and lasts for 15 minutes.
To stop, press on/Key for 1 second.
8
2024-01-23 BluMill Ice Cube Maker ManualV02.indd 8
2024-01-23 BluMill Ice Cube Maker ManualV02.indd 8
C).
0
20-02-2024 14:29
20-02-2024 14:29
Advertenties
Inhoudsopgave
