Programming The Remote Control; Programming The Sc811 - Becker Centronic SensorControl SC811 Gebruiksaanwijzing

Zon-wind

Verberg thumbnails Zie ook voor Centronic SensorControl SC811:

Inhoudsopgave

Advertenties

Beschikbare talen

Programming the remote control

Note

Before the SC811 is programmed, a master transmitter (e.g. SWC441)

must be programmed in the receiver (e.g. tubular drive R30/17PSF(+))

and the ﬁ nal positions pre-programmed.

Caution

Before programming the master transmitter, always ensure that there

are no obstructions in the immediate operating area of the sun protec-

tion system, as the system may extend unexpectedly.

The SC811 features an integrated radio transmitter.

a) Press the programming pushbutton of the master transmitter until acknowl-

edgement is given by the receiver.

b) Press the programming pushbutton on the SC811 until the receiver conﬁ rms

the signal setting.

c) Now press the programming pushbutton on the new SC811 to be programmed

once more.

The receiver will indicate when the learn process has been successfully com-

pleted.

The maximum radio range is up to 25 m indoors and up to 350 m in the open.

Inhoudsopgave

Advertenties

Inhoudsopgave