Advertenties
Beschikbare talen
Beschikbare talen
USING YOUR DISHWASHER
Adjusting salt consumption
The dishwasher is designed to allow for adjustment in the amount of salt consumed based on
the hardness of the water used. This is intended to optimise and customise the level of salt
consumption. Please follow the steps below for adjustment in salt consumption.
1.
Switch on the appliance;
2.
Press the Program button for more than 5 seconds to open the water softener settings
mode within 60 seconds after the appliance was switched on;
3.
Press the Program button to select the correct setting according to your local environment.
The settings will change in the following sequence:
H1->H2->H3->H4->H5->H6;
4.
Press the On/Off button to confirm the setting and to end the setting mode.
Adding salt
1.
Remove the lower basket and unscrew the reservoir cap.
2.
Place the end of the funnel (supplied) into the container
3.
Fill the salt container to its maximum limit with dishwasher salt (about 1.5 kg). It is normal
for a small amount of water to come out of the salt container.
4.
After filling the container, put back the cap (tighten firmly).
5.
The salt warning light will go off after the salt container has been filled with salt.
6.
Immediately after filling the salt into the salt container, a washing program should be
started (we suggest to use a short program). Otherwise the filter system, pump or other
important parts of the machine may be damaged by salty water. This is out of warranty.
Note! The salt container must only be refilled when the salt warning light in the control
panel comes on. Depending on how well the salt dissolves, the salt warning light may
still be on even though the salt container is filled. If salt has spilled, run a soak or quick
program to remove it.
EN 9
Advertenties
