Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
INSTALLATION
Making the worktop recess
● The kitchen area should be dry and aired
and equipped with efficient ventillation.
When installing the cooker, easy access
to all control elements should be ensured.
This is a Y–type design built–in cooker,
which means that its back wall and one
side wall can be placed next to a high
piece of furniture or a wall.
● Worktop thickness should be 28 - 40
mm, while its width at least 600 mm. The
worktop must be flat and level. Edge of the
worktop near the wall must be sealed to
prevent ingress of water or other liquids.
● There should be sufficient spacing around
the opening, in particular, at least 50 mm
distance to the wall and 60 mm distance
to the front edge of worktop.
● Worktop must be made of materials, in-
cluding veneer and adhesives, resistant
to a temperature of 100°C. Otherwise,
veneer could come off or surface of the
worktop become deformed.
● Edge of the opening should be sealed
with suitable materials to prevent ingress
of water.
● Worktop opening must cut to dimensions
as shown on figure.
● In the back section of the protection plate
a notch should be made with a width of at
least 80 mm.
* some models come with the sealing glued to the board
Installation of self-adhesive foam
gasket *
Do not install the appliance without the
foam gasket.
The gasket must be applied on the appli-
ance as follows:
Before fitting the appliance in the kitchen
worktop, apply self-adhesive foam gasket
provided underneath the rim.
- before applying, remove the protective film
from the self-adhesive foam gasket
- apply the self-adhesive foam gasket under-
neath the appliance rim
(Figure)
10
Advertenties
Hoofdstukken
Inhoudsopgave
