Intended Use - Becker Centronic SensorControl SC711 Montage- En Gebruiksaanwijzing

Verberg thumbnails Zie ook voor Centronic SensorControl SC711:

Inhoudsopgave

Advertenties

Beschikbare talen

The sensor described in this instruction manual must only be used for operat-

ing Centronic-compatible radio drives and radio control units. The sensor is in-

tended solely for the operation of sun protection systems. Use for other pur-

poses or for purposes beyond the above constitutes improper use.

• Please note that radio-controlled systems may not be used in areas with

a high risk of interference (e.g. hospitals, airports).

• The remote control is intended solely for use with equipment and sys-

tems in which malfunctions in the transmitter or receiver would not pose

any risk to persons, animals or property, or which contain safety devices

to eliminate such risks.

• The operator is not protected from interference from other telecommu-

nications systems and terminal equipment (e.g. even from radio-con-

trolled systems which are properly operated in the same frequency

range).

• Only connect radio receivers to devices and systems approved by the

manufacturer.

•

Ensure that the control unit is not installed or operated

close to metal surfaces or magnetic fields.

•

Radio-controlled systems transmitting on the same fre-

quency may cause reception interference.

•

Note that the range of the radio signal is limited by legis-

lation as well as by design.

Intended use

15 - en

Inhoudsopgave

Advertenties

Inhoudsopgave