Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
en first time
After the appliance has switched off,
the drives will continue moving for a
few seconds until the correct parked
position is reached.
Note: The swivel arm will only open
or close with the inserted tool when
the drive is located in the correct
parked position.
The following causes result in an
incorrect parked position:
¡ The power supply was interrupted
during processing.
¡ A safety system terminated pro-
cessing.
¡ During processing the swivel arm
disengaged or the release button
for the swivel arm was pressed.
Tip: You can easily adjust an incor-
rect parking position yourself.
→ "Troubleshooting", Page 39
5.8 Safety systems
You can find an overview of your ap-
pliance's safety systems here.
Start lock-out
Start lock-out prevents your appli-
ance from being switched on acci-
dentally.
The appliance can only be switched
on and operated if
¡ the swivel arm is engaged in posi-
tion 1 and the bowl or an access-
ory is inserted, e.g. Ice maker.
¡ the swivel arm is engaged in posi-
tion 3 and the protective cover or
an accessory is fitted on drive 3.
Restart lock-out
Restart lock-out prevents your appli-
ance from automatically restarting
processing after a power failure.
The appliance is switched on again
after a power failure. Processing can-
not start again until the rotary switch
has been set to
34
.
Overload protection
The overload protection system pre-
vents the motor and other compon-
ents from being damaged through
being overloaded.
The motor will switch off if
¡ too large a quantity is processed.
¡ a tool or accessory is blocked.
first time
6 Before using for the
first time
Prepare the appliance for use.
first time
6.1 Preparing the appliance
Press the release button and raise
1.
the swivel arm until it engages.
→ "Moving the swivel arm",
Page 35
Turn the bowl clockwise and re-
2.
move.
→ "Removing bowl", Page 35
Clean all parts that come into con-
3.
tact with food before using for the
first time.
→ "Cleaning and servicing",
Page 37
Put the cleaned and dried parts
4.
out ready for use.
operation
7 Basic operation
operation
7.1 Cable length
Adjust the length of the power cable
to your needs.
Adjusting cable length via cable
storage compartment
Pull the power cable out to the re-
1.
quired length.
To shorten the cable, push it into
2.
the cable storage compartment.
Advertenties
Hoofdstukken
Inhoudsopgave
