Becker Centronic TimeControl TC445-II Gebruikers- En Montagehandleiding pagina 42

Verberg thumbnails Zie ook voor Centronic TimeControl TC445-II:

Advertenties

Beschikbare talen

Programming the transmitter

1) Programming the master transmitter

a) Readying the receiver for programming

The master transmitter refers to the very first transmitter

programmed in a receiver. In contrast to subsequently pro-

grammed transmitters, the master transmitter enables,

among other things, the setting of limit positions and the

programming or deleting of further transmitters. Any trans-

mitter that has separate UP, STOP, DOWN buttons and a pro-

gramming button can be a master transmitter.

Follow the Assembly and Operating Instructions for the re-

ceiver.

Operate the programming button on the transmitter using a

suitable cylindrical tool (e.g. a ballpoint pen).

• Switch off the power supply to the receiver for 5 seconds, then switch it

back on

• Operate the programming button or the radio switch of the receiver.

The receiver is now in programming mode for 3 minutes.

b) Programming the master transmitter

Press the programming button on the master transmitter while in program-

ming mode until the receiver confirms that programming has been successful.

The programming process is now complete.

2) Programming additional transmitters

Press the programming button of the master transmitter until the re-

ceiver confirms.

Then press the programming button of the new transmitter until the re-

ceiver confirms.

Now press the programming button of the new transmitter again.

The receiver confirms successful programming.

42 - en

Advertenties