Advertenties
Beschikbare talen
Beschikbare talen
D) Combined with built-in spotlight WDS-3 (picture 8)
(Built-in spotlight WDS-3 not included)
Outside the pond, glue (C) a Ø 50mm glued socket (6) to the PVC pipe
(4).
Mount the cable seal (7) 900mm from the plug (2) on the cable (5) of
the spotlight. Make sure that the half-moons (11 + 13) of the cable seal
(7) are positioned crosswise opposite one another with the rubber seal
(12) in between. Make sure that the bolts can be tightened outside the
pond.
Run the cable (9) plug (2) from outside of the pond through the PVC
glued socket (6), PVC pipe (4) and wall conduit (3).
Tighten the four bolts evenly with the supplied Allen key (10) until the
cord seal (7) creates a watertight seal around the cord seal (7), the
glued socket (6) and cord (5).
Screw the plug (2) to the spotlight (1). Make sure that the plug (2) is
tightened securely.
If you wish to use the black rubber cover (14), place it on the spotlight
(1).
Fold the cable (5) in the PVC pipe (4) so that you can turn the spotlight
(1) in the wall conduit (3) by inserting it in the wall conduit (3) and
turning it clockwise until it stops turning and is secured in place (bayonet
catch).
Connect the protruding cable to a suitable transformer.
Thanks to the specified installation depth (A), PVC pipe length (4) and cable
length (5) dimensions, the light can simply be replaced by taking it out of the
water and inserting a new lamp.
With different installation depths (A), the length of the PVC pipe (4) and cable (5)
must be modified.
E) Combined with built-in spotlight WDS-1 (picture 9)
(Built-in spotlight WDS-1 not included)
Outside the pond, glue a Ø 50mm glued socket (10) to the PVC pipe (8).
Mount the cable seal (11) 900mm from the plug (6) on the cable (9) of
the spotlight. Make sure that the half-moons (13 + 15) of the cable seal
(11) are positioned crosswise opposite one another with the rubber seal
(14) in between. Make sure that the bolts can be tightened outside the
pond.
Run the cable (9) plug (6) from outside of the pond through the PVC
glued socket (10), PVC pipe (8) and wall conduit (7).
Tighten the four bolts evenly with the supplied Allen key (12) until the
cord seal (11) creates a watertight seal around the glued socket (10)
and cord (9).
Turn the ring (1) of the water jet (5) and remove the ball bearing (3).
Remove the o-ring (4) from the water jet (5).
Run the plug (6) through the water jet (5) and connect the plug (6) to
the spotlight (2). Make sure that the plug (6) is tightened securely.
Slide the spotlight (2) into the water jet (5) and connect the ring (1) to
the water jet (5).
Fold the cable (9) in the PVC pipe (8) so that you can turn the water jet
(5) with spotlight (2) in the wall conduit (1) by inserting it in the wall
conduit (1) and turning it clockwise until it stops turning and is secured
in place (bayonet catch).
English
www.auga.nl
17
Advertenties
