Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Battery charger
The supply voltage must correspond to the voltage indicated on the type plate of the
rapid charger.
Always inspect the battery charger, cord and plug before use.
Always have damage repaired by a qualified professional.
Protect the battery charger from moisture and only use it in dry areas.
The battery charger supplied is only suitable for charging batteries.
Charging the battery pack
To start charging, insert the charger plug into the battery pack and connect the
battery charger to the mains outlet.
The battery pack and charger will become warm during charging, this is normal.
When charging is complete, unplug the charger from the power outlet and disconnect
the charger from the battery.
LED indicator on charger:
About the charger
Disconnect the power supply before connecting or disconnecting the battery
The charger must only be used with a rechargeable battery. Never use a non-
rechargeable battery.
Do not expose the charger to rain or water
Inserting and removing the rechargeable battery
Insert the rechargeable battery into the device, paying attention to the correct
orientation between the battery and the battery compartment. Do not apply force
when inserting the battery. The battery can be inserted easily and without resistance.
The battery must be fully inserted until the battery retaining clips on the sides of the
battery compartment automatically lock the battery in place. To remove the battery,
press down on the battery retaining clamps and pull the battery out of the
compartment.
Inserting the Tool
Important! Always remove the battery pack before changing the drill or screwdriver bit
to prevent the machine from starting unintentionally.
The cordless drill has a keyless chuck so that you do not need a spanner to secure
the tool bit. Make sure that the drill or screwdriver bit is not slanted when it is inserted
and the drill chuck is tightened.
Before inserting drill/screw bits, open the chuck jaws by holding the lower ring of the
chuck and turning the locking ring anti-clockwise.
Open the chuck until you can insert the tool. Hold it and then turn clockwise to secure
it.
To remove the tool, hold the machine and turn the chuck anti-clockwise.
Open the chuck until you can remove the tool.
red indicator: charging.
Green indicator: charging complete.
22
Advertenties
Inhoudsopgave
