Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
GB
Motor with electronic limit switches
If it is certain that the motor used is one with electronic limit switches, the
measurement described above can be dispensed with.
It is not possible to damage the insert with motors equipped with electronic
limit switches if these are used in conformity with their designated use.
In this case, check the basic functions of the motor in combination with the
RolloTec
• Install the RolloTec
• Plug a shutter control attachment into the insert.
• Test the functions of the shutter control in several trial runs with the motor
30
®
'Standard' insert without neutral conductor as follows:
®
'Standard' insert without neutral conductor as described
in chapter 5.
connected.
GB
5. Connection and fitting
The RolloTec
®
'Standard' insert without neutral conductor is connected in acc.
with the opposite figure.
Install the RolloTec
®
'Standard' insert without neutral conductor (1) in a
mounting box in acc. with DIN 49073 (deep box recommended).
The conecting terminals of the insert must be at the bottom.
Plug the attachment (2) together with frame (3) into the insert.
The electrical contact is established through connector (4).
The additional contact pins (5) in attachments with sensor input make automatic
contact with the 3-pole terminal block placed into the insert.
31
Advertenties
Hoofdstukken
Inhoudsopgave
