Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Whirlpool 4 Button - User Manual
EN
5.2.1
Hydro jet
Hydro jets have a complete chrome surface finish. The flow can be set, by pointing the opening in the
middle of the jet in the desired direction. This movement is quite heavy. Otherwise the opening would
easily turn back in its straight position, as a result of the water- and air pressure.
5.2.2
Hydro Lux jet
The Hydro Lux jet has a complete chrome surface finish. The flow through the jet can be directed
stronger or softer. By turning the inner part of the jet by hand the flow can be adjusted. When the inner
part is turned clock wise, the flow will be less heavy.
6.0
Protection system
If there is insufficient water in the bath, the system will not switch on in order to prevent the pumps from running dry.
In addition all motors are fitted with a thermal switch. These will switch off the motors in the event of problems.
6.1
Disinfection and cleaning.
Application of (Riho) Cleaning products; Cleaning liquid, Cleaning/disinfect tablets and Soda.
Whirlpool Cleaning Products are for cleaning/disinfecting the Hydro System. An Aero system blows air only and
can't/doesn't need to be cleaned with a special product.
Two products;
1. Riho Cleaning/disinfect Tablets (not available in Belgium)
2. Soda
3. Riho Cleaning Liquid (for hotel tubs)
The RIHO cleaning products are mild in composition and ideal to use in our RIHO whirlpools.
During normal use of the whirlpool it is advisable to clean it every 4 to 5 whirlpool turns, interspersed with
cleaning liquid and tablets. By little use of the whirlpool, it is advisable to clean the bath in advance, so that the system
is clean before using.
1. Cleaning Tablets
Cleaning Tablets are to disinfect the Hydro System.
Fit the bathtub over the top jets. Put RIHO CLEAN cleaning tablets into the tub - 1 tablet per 50 liters of water. Start
the massage system for 10 minutes, then leave the water in the tub for another 10 minutes. Run the system again for
2 minutes. Drain water and wash out the bathtub thoroughly with cold water. The bath can be used immediately after
wash out. When using the whirlpool regularly, repeat cleaning once a month.
2. Major cleaning cycle with Soda
When you see black flakes in the water during the use of the whirlpool system we recommend cleaning with soda. Fill
the whirlpool just above the upper jet. Add a bag of soda to the water and make sure it is resolved because otherwise
it can cause scratches. Turn the Hydro system manually on and off (1 ½ to 2 minutes each time, repeat this 4-5 times
for good flushing of all tubes and hoses). This bath water can soak overnight so that it loosens stubborn dirt.
In the morning you repeat the process and you can empty the dirty water from your whirlpool.
For stubborn stains, the procedure may be repeated two or more times. The black flakes would be less at every turn
and eventually disappear.
3. FOR HOTEL TUBS: Clean Liquid / Cleaning Fluid
This is for the cleaning of the hydro system. You fill the tub to just above the upper jets.
Fill the clean-tank with clean liquid. The whole bottle fits in the tank and lasts fo
Please follow chapter 4.1.7 of this manual. After end of whole process, drain the tub and rinse with clean water.
r 6-8 cy
-11-
Riho
cles.
Advertenties
Hoofdstukken
Inhoudsopgave
