Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Whirlpool 4 Button - User Manual
EN
Power on:
When the system is in standby state and any button on the panel is touched, the panel will power on and the button
icons will now light up dimmed. If there is no further operation in the following 30 seconds the system will return to the
standby state. When the power is on, the buttons can be used to turn on and off the according functions. When a
function is 'on', the backlight of this button is on as well. When the function is turned off the backlight of this button will
return to its dimmed state.
Shutting down:
The default operating time is 30 minutes. If there is no operation within these 30minutes, the system will shut off
automatically and return to its standby state. If you have touched any button, the working time will be 30 minutes from
the moment the last button was touched.
Figure 7
4.1.2
Colour therapy.
Touch the "
"button on the control panel to turn on/off the white light and chroma light (both lights can be on/off
together). The chroma light will change colour automatically once activated and the backlight of the button repeatedly
turn on/off at this time. When you reach your preffered colour you can lock it by touch and holding the "
for 2 seconds. The backlight of the button will be on in this mode (not dimmed). To resume the colour loop touch and
hold the "
"button for 2 seconds again. The backlight of the button will again fade in and out repeatedly.
4.1.3
Aero function.
Touch the "
"button on the control panel to power on/off the aero function. When the bath is filled (waterlevel is
sufficient), the aero pump will start working and the "
at its maximum speed (level 5). When the bath is filled (waterlevel is sufficient) and you touch and hold the
"
"button for 2 seconds the button will blink and the speed will turn up one level at the time. After level 5 it returns
to level 1 then 2, 3, 4 and then back to 5. When the bath is empty (waterlevel is not sufficient), the aero function will
not work. But when it is empty you can touch and hold the "
the button will then light up (not dimmed). The dry function starts blowing from level 1 to level 5 for a period of 15
seconds each step, once level 5 has finished the dry function stops and the backlight of the button will be dimmed.
This whole dry cycle takes 75 seconds.
4.1.4
Hydro function.
Touch the "
"button on the control panel to power on/off the hydro function. When the bath is full (waterlevel is
sufficient), the hydro pump will start working and the "
(waterlevel is not sufficient), the hydro function will not work and the backlight will stay in a dimmed state. This also
happens when the hydro function is on and the water level drops under the minimum level. The hydro function will
then stop and the backlight will return to a dimmed state.
4.1.5
Music / Bluetooth function.
Touch the "
"button on the control panel to power on/off the music/Bluetooth function. Note that the
music/Bluetooth function will not work untill the Bluetooth is connected with the Bluetooth device. If not paired with a
Bluetooth device and the button is touched, the backlight of the "
the backlight of the "
Colour Therapy
Aero
"button will stay on (not dimmed).
Hydro
Music / Bluetooth
"button will light up (not dimmed). The aero pump will start
"button to activate the dry function. The backlight of
"button will light up (not dimmed). When the bath is empty
"button will repeatedly blink. Once it is paired,
-9-
"button
Advertenties
Hoofdstukken
Inhoudsopgave
