Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
2. INTRODUCTION
2.1GENERAL DESCRIPTION
WELDKAR PLASMA 4060 PFC
With its handy and portable construction, the Weldkar
WK Plasma 4060 PFC is excellent for cutting on site and
of course in the workshop as well. With its output of 40
amps on 230 volts, this machine can cut through steel
up to 18 mm thick. The advanced inverter technology
gives this machine high cut quality. The on-air plasma
arc ignition system provides safe and optimal ignition.
This plasma cutter is equipped with a 6-meter Weldkar
plasma torch and a pressure regulator. The machine
is provided with CE, EMC and PFC (Power Factor
Correction) and suitable for generator use.
The plasma inverter is supplied as standard with a:
-
WK Plasma 4060 Inverter Power source
-
Power cable 5 meter, 3 x 2.5 mm²
-
230 Volt power plug
-
Earth clamp with 4-meter earth cable and DIN Plug
-
Air hose
-
Plasma cutting torch PT 60 - 6 meter
-
Operating manual
The instructions below provide detailed information for
the correct and safe use of the machine and instructions
for obtaining the greatest efficiency and quality from
your power source.
IT MUST NOT BE USED TO DEFROST PIPES.
2.2 TECHNICAL SPECIFICATIONS:
Model
Mains voltage 1-phase
Frequency
Fuse rating
Current adjustment range
Duty Cycle (40% - 10 min.)
Open circuit voltage
Max. thickness
Stepless regulation
Air consumption
Protection Class
Isolation Class
Weight
Dimensions (LxBxH)
16
INVERTER PLASMA CUTTER WK PLASMA 4060 PFC
WK Plasma 4060 PFC
230 Volt / ± 10%
50 / 60 Hz
20 A (slow blow)
20 – 40 A
40 A – 60%
30 A – 100%
220 Volt
18 mm (steel)
Electronic
150 l/min – 5,0 bar
IP 23
H
7,6 kg
420 x 135 x 290 mm
2.3 EXPLANATION OF THE TECHNICAL
SPECIFICATIONS LISTED ON THE
MACHINE PLATE.
This machine is manufactured according to the following
international standards: IEC 60974.1
N°
Serial number. Must be indicated on any
request regarding the welding machine.
Single-phase static transformer-rectifier
frequency converter.
Suitable for Plasma cutting.
U
Secondary open-circuit voltage.
0
X
Duty cycle percentage. % of 10 minutes
during which the welding machine may run
at a certain current without overheating.
I
Welding current.
2
U
Secondary voltage with current I
2
U
Rated supply voltage.
1
I
Max. absorbed current at the
1max
corresponding current l
I
This is the maximum value of the actual
1eff
current absorbed, considering the duty
cycle.
IP23
Protection rating for the housing. Grade
3 as the second digit means that this
equipment may be stored, but it is
not suitable for use outdoors in the rain,
unless it is protected. Suitable for use in
high-risk environments.
H
Isolation Class.
AF
Aircooling with fan.
2.4 THERMAL PROTECTION
This inverter is protected by a thermostat. When the
thermostat is tripped, the machine stops delivering
current but the fan continues to run. The yellow led (4)
lights to indicate when it is tripped. Do not shut off the
welding machine until the led has gone off.
.
2
and voltage U
.
2
2
Advertenties
Hoofdstukken
Inhoudsopgave
