Programming The Remote Control; Setting The Swc510 To Programming Mode; Programming Master Transmitter - Becker Centronic SunWindControl SWC510 Gebruikers- En Montagehandleiding

Inhoudsopgave

Advertenties

Beschikbare talen

Assembly and Operating Instructions

Programming the remote control

Note

Ensure that optimum radio reception is achieved.

The threshold values for sun protection and wind control can be set

with the following transmitters: Centronic SunWindControl SWC441,

SWC411 and SWC545.

If the transmitter's sliding switch is moved from "H" to "S" or vice ver-

sa, the shutter/awning/blind will "nod" to confirm the change.

Setting the SWC510 to programming mode

a) Set the SWC510 to programming mode by switching on the power sup-

ply

Switch on the power supply.

The SWC510 will remain in programming mode for 3 minutes.

b) Set the SWC510 to programming mode using the programming button

Press and hold the programming button for 3 seconds.

The SWC510 will remain in programming mode for 3 minutes.

Programming master transmitter

Press and hold the programming button for 3 seconds while in programming

mode.

The system will confirm the programme setting with a 'nod', i.e. the shutter/

awning/blind moves a few centimetres in one direction and then reverses the

same distance.

This confirmation is hereafter referred to as 'nodding'.

The programming process is now complete.

Note

If a transmitter has already been programmed in the receiver, press the

programming button and hold for 10 seconds.

Inhoudsopgave

Advertenties

Inhoudsopgave