Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
EN
EN
WARNING! Do not use the convector in areas where are used or stored flammable or
combustible substances (including gases and aerosols)! Do not use the convector in areas
with flammable atmospheres! There is a great danger of fire and explosion!
WARNING! Do not use this heater in small rooms when they are occupied by persons not
capable of leaving the room on their own, unless constant supervision is provided.
WARNING! To reduce the risk of fire, keep textiles, curtains, or any other flammable
material a minimum distance of 1 m from the air outlet.
WARNING! Do not leave the unit turned on for a long time unattended! Switch off the unit
from the mains whenever you do not use it for a long time (how to use the Anti-freeze
function please refer to the section How to use the appliance). Make sure the appliance is
disconnected from the switch before unplugging the power cord!
WARNING! Do never move the convector while plugged in, when running or hot! When
moving use the handles for carrying (pos. В on Fig. 3).
WARNING! Never place the power cord on the appliance while it is running or warm! Do not
use the cord to move the appliance, do not crush it, and do not pass it over sharp edges! It is
forbidden to extend the power cord in any way!
WARNING! The convector power cord plug can only be connected to a protected single
phase power outlet with voltage 230 V~.
ATTENTION! The appliance should NOT be positioned in the immediate vicinity of mains
sockets. The socket where the unit is switched on must always be easily accessible to allow
plug disconnection as quickly as possible when needed. Fig 5.
WARNING! Do never use the heater without the supports for floor mounting. There is risk of
fire! Before turning on the heater for the first time, you need to install the supports as shown
in Fig. 2. Place the convector lying and put the supports at its bottom, making sure that the
power cord is put through as prescribed in the instructions and does not interfere with the
tightly fitted together unit elements. Fix firmly the supports - hook the supports in the
openings and use the supplied screws (one screw for each support). Sloped openings
should point to the front panel of the appliance.
WARNING! Never clean convector while plugged in, when running or hot!
WARNING! After cleaning the heater it is compulsory to place it back in its normal position
(according to fig. 1), before switching it on. The connection of the convector to the mains is
only permitted after the complete removal of any moisture!
14
Advertenties
Inhoudsopgave
